Tovább az oldal tartalmához

Flexible Table Microphone Boom Arm

  • 3/8" to 5/8" threaded connector
  • Max. load: 0.8 kg
  • Clamping range: 10 - 51 mm
  • Length: 460 - 960 mm
  • Material: Steel
  • Weight: 1.38 kg
  • Colour: Black
  • Suitable table flange: Article Nr. 158140 (not included)
  • Includes 4 cable clips
  • katalógusunkba bekerült: Július 2020
  • Termékszám 497308
  • mennyiségi egység 1 darab
  • Type Microphone Boom
  • Height 460 mm – 960 mm
  • Colour Black
21 777 Ft
Minden ár tartalmazza az ÁFÁ-t
Azonnal szállítható
1

71

4.5 / 5

stabilitás

kivitelezés

42 Vélemények

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
D
Noisy and instable
Djangi 06.11.2020
When using a lighter mic (sm57) the springs tend to be too strong. This can be partially solved by tightening the clamps in the joints.
When using a heavier mic (sm7b) the springs are not strong enough, it's almost impossible to retain a 90 degree angle (it usually falls back to 75).
The spring are also very noisy which can affect your recordings.
The mic connector is too close to the joint for use with a SM7B which causes stress on the cable/connector. you can solve this with an extender like the Shure A26X.

Unfortunately I noticed most of the issues after spending quite some time with it, would have returned it otherwise. I'm probably going to replace it with the Rode PSA-1.
4
2
Jelentem!

Jelentem!

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
A
Solid.
Abdstract 19.08.2022
It does the job, good quality, stable and solid.
kivitelezés
stabilitás
0
0
Jelentem!

Jelentem!

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
s
salik 14.03.2024
Great product, very flexible and very easy to configure.
A recommendation if you need a mic arm.
kivitelezés
stabilitás
0
0
Jelentem!

Jelentem!

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
F
Perfectly Decent, Decently Perfect
FlashTheDeliveryGuy 18.09.2026
As long as you are using the standard spread of dynamic microphones and small condensors you should be fine: however once you graduate to larger and heavier microphones I do find that mine struggles to hold position.
kivitelezés
stabilitás
0
0
Jelentem!

Jelentem!